Homies. There are many ways to do this but which way would be the easiest and most effective? I’m dreading making a template
I need to translate and drill these 3 holes to my new bumper to attach a trim piece with studs going thru it
cardboard template, should only take 5 - 10 minutes to translate the outline of the bumper and the 3 holes, then match it up with the new unit. Do you have a phobia of templates?
I kind of do. I don’t like tracing out the corner and the arch, guess I’ll have to try
A sheet of paper and rub over it with the side of the pencil tip.
eyeball and hope for the best
shame on you!
Come on @Eric, this isn’t engineering, just knock it out.
Toothpaste on the holes and then pres it up against the fender then boom.
No because the trim that I’m attaching has studs on it, which go through those 3 holes that need to be drilled.
I am just going to yolo this and get it over with. I’ve been pulling axles and installing brakes instead to avoid this…
I believe in you, Eric! <3 <3 <3
Don’t be silly. Just send it
Make sure you pilot drill it first.